Tiles do not worry about such stickers off again!
Because the bathroom and the kitchen are relatively humid, the decoration is mainly based on tiles, but for a long time, the tiles will fall off due to a variety of reasons, this will affect the appearance of the home improvement, why the tiles fall off? Some are caused by construction when paving, and the other is that moist air reduces the useful life of tiles. First, the wall base must be cleaned In many cases, there is a big relationship between the shedding of the tiles and the unsatisfactory handling of the grass roots. Therefore, if you want to stick the tile firmly, be sure to clean the wall dirt! In this way, when the tile is laid, the cement mortar can be better bonded with the wall and the ground. In addition, if the wall is cracked, it must be handled before the tiles are tiled. Otherwise, in the future, not only can the tiles be cracked, but also the waterproofness of the bathroom becomes large. Problem. Second, the base layer of the tiles must be fully moistened When using cement mortar to bond tiles, it is important to ensure that the tiles are full of mud, as well as the moisture level at the base level. Before the tile is laid, the base layer should be fully watered, especially on the wall surface, and sprinkled with water and moistened in advance for a certain period of time so as to avoid the cement mortar moisture being absorbed by the dry base layer and affecting the bonding strength. Third, the ground should be laid flat and then tiled The ground of the bathroom space should be leveled first. It can be leveled with cement mortar and then tiled. However, the bathroom is not the same as other spaces. The bathroom needs to have a drainage design, that is, to find the slope according to the drainage direction. When the tile is tiled, the drainage position is low. This design prevents space water accumulation. On the one hand, it can be used after the bathroom is put into use. Keep the bathroom space dry from time to time, on the other hand, it also helps maintain the tiles. Fourth, tiles should be fully water One of the reasons why tiles are soaked in water is that they have a certain rate of water absorption. In particular, the wall tiles have a high water absorption rate. After soaking in water, they can avoid the sewage that they absorbed the cement slurry when they were laying. Another reason is that water bubbles can make Tiles have a stronger bond. Therefore, it is recommended that before the bathroom is tiled, the tiles should be treated with water soaked in the tiles. Tips: More practical decoration knowledge, real scene with the shoot, please pay attention to the palm of this site (micro signal: mall_jia). Tile decoration construction knowledge
Precision electroforming 75 Test Sieve, Material Screening and Testing in Laboratory
Laboratory Test Sieves,Standard Sieve,Laboratory Standard Test Sieve,Electroformed Test Sieve Xinxiang Xin Ming De Machinery Co., Ltd. , https://www.xmdsieve.com
