The late management of loofah is a good way to keep the seeds and melons

The vegetable farmers often take the loofah seeds in the late stage of loofah. In general, the plants after seeding are no longer in normal production of loofah. However, it takes 80 to 90 days for the loofah to sit on the melon to ripen the seeds. In this nearly three months, only cultivating the seeds will inevitably affect the benefits of loofah production. If you manage it in the late stage of loofah, you can ensure that the loofah is kept in the same way. Linyi Fertilizer Network Copyright
Linyi Fertilizer Network Copyright
1. When the loofah enters the planned seeding period, one side of the vine is reserved in the lower part of the melon strip that is planned to be kept. After the main vine is topped, the side vine is replaced by the main vine. Linyi Fertilizer Network Copyright
Linyi Fertilizer Network Copyright
2. At least 5 to 6 leaves should be kept above the melons of the main vines to ensure the nutrients needed for seed development. Linyi Fertilizer Network Copyright
Linyi Fertilizer Network Copyright
3. Side vines should be hanged in time, and it is not advisable to leave melons for 15 days after the main vines are kept in order to prevent the competition from affecting the normal development of the seeds. Because the loofah melon strips are basically finished in about 15 days, and enter the seed maturity period, so in order to avoid the seedlings being too small or the melons are swollen slowly, it is not appropriate to leave melons on the side vines. At the same time, the nutrition produced by the side vine leaves can also supply a large amount of growth of the seed melon, which is convenient for increasing the quantity and quality of the seed to be cultivated. Linyi Fertilizer Network Copyright
Linyi Fertilizer Network Copyright
4. In the early stage of the side vine, the anther concentration at the time of flowering should be small. Formulation: Add 10 ml of capsules, 6 ml of 2,4-D, 10 ml of naphthaleneacetic acid, 10 ml of flower buds, 12 ml of loofah, 20 ml of green source, 1 gram of rotten spirit, and fruit in 2 kg of water. Spirit can be added first to reduce the competition for nutrition, avoid hormone poisoning, and cause premature aging of plants. After 80 to 90 days, after harvesting the melon, the concentration of the anther can be appropriately increased. 2,4-D can be added to 8 ml, and 10 ml of the fruit can be added. Linyi Fertilizer Network Copyright
Linyi Fertilizer Network Copyright
5. Although the roots of loofah are developed, after entering the seeding period, the loofah has entered the late stage of production, and the plants are inevitably declining. Therefore, in order to ensure the retention and the melons, it is necessary to increase the amount of fertilizer. Top dressing can be done by flushing and foliar application. It can be combined with biological fertilizer and high-potassium fertilizer to achieve the purpose of promoting roots and nourishing trees, keeping flowers and fruits. The biological bacterial fertilizer is applied for 20 to 25 kilograms per acre; the high-potassium fertilizer is applied for 15 to 20 kilograms per acre. It can also be applied with potassium sulfate compound fertilizer, and 25 to 30 kilograms per acre. Foliar spray fertilizer is mainly to supplement the deficiency of rhizosphere topdressing, to meet the large demand for nutrition of loofah and seedlings, and to spray full-nutrient foliar fertilizer. Linyi Fertilizer Network Copyright
Total 1 | <First <Prev 1 Next> Last> |
share to:

Electrical Lockout equipment is used for locking out switched off circuit breakers, preventing re-energising, to control dissipation of residual energy, to ground electricity and also to effectively tagout equipment.

The plug completely sits inside the unit with the cable being fed through an access hole inside.Completely encloses electrical plugs to prevent accidental re-connection.

Our Electrical Plug Lockout devices accommodate a large variety of plug shapes and sizes and some require a key to prevent unauthorized plug connections.Device is made of rugged polypropylene and is for use with 110V,220V and 500V electrical plugs. 

Surrounds the electrical plug and protects against accidental reconnection.Avoid electrical accidents by applying lockouts to prevent plugs from being inserted into a wall outlet. Use when plug will not remain under the exclusive control of the person performing service or maintenance.

electrical lockout

Electrical Lockout

Electrical Lockout,Electrical Lock,Electric Lock,Stop Lockout

Lockey Safety Products Co., Ltd. , https://www.lotolockey.com