Novices need to know the new house acceptance criteria
During the initial phase of a renovation, it's crucial to thoroughly inspect the property, especially if it's a new or unfinished house. A detailed examination of the structure is necessary, covering walls, doors, windows, and balconies. This step helps identify any potential issues that could affect the construction process and budget planning. Early detection of problems allows for timely communication with the developer or contractor, preventing minor issues from escalating into major ones. This proactive approach can save time, money, and stress down the line. First, inspect the house for cracks. 1. Carefully examine the floor and ceiling for any visible cracks. If you find them, determine their type and severity. Cracks parallel to the beams are usually not a big concern and can be fixed without affecting the usability of the space. However, if the cracks form a 45-degree angle at the corner of a wall or run perpendicular to the beam, it may indicate serious structural issues due to foundation settlement. 2. Check the exterior walls for cracks. Any visible cracks on the outside should be taken seriously as they may signal deeper quality concerns. 3. Inspect load-bearing walls for cracks. If a crack runs through the entire wall and shows signs of wear, it could mean a structural hazard. In such cases, it's best to avoid moving forward with the purchase unless the issue is fully resolved. Second, check for tilting in the building. A simple method involves hanging a weighted rope from the roof and measuring its alignment with the base of the wall. This can help detect any uneven settling or tilt in the structure. Third, look for signs of water leakage. Buyers should pay close attention to water seepage on the floors and ceilings. Discoloration, blistering, peeling, or flaking on the walls are all red flags. Additionally, check the kitchen, bathroom, balcony, and pipe connections for any signs of leaks. Fourth, examine the walls and flooring. 1. For a rough-built living room, ensure the walls are smooth and even. Any irregularities should be noted. It’s recommended to conduct this inspection the day after heavy rain, as this is when any hidden wall issues are most likely to show up. 2. Check for "lime explosion" on the walls. This occurs when lime isn’t fully matured or when cement has excessive sediment. When tapped with a metal object, it may cause large areas of the surface to become loose or fall off. 3. The floor should be smooth and free of sand. A bumpy or gritty surface can indicate poor construction quality. 4. Verify that the tiles in the kitchen and bathroom are properly laid. There should be no cracks or hollow spots, and the tiles must be firmly attached. 5. Ensure that the bathroom and kitchen floors have proper slope for drainage. Water should flow naturally toward the drain and not towards the door or into the room. Sixth, inspect the doors and windows. The focus here is on window and balcony door sealing. While the best way to test for air or water tightness is during rain, you can also check the condition of the sealing strips. They should be intact and secure. For balcony doors, check the level difference between the inside and outside. If the levels are the same, there’s a higher risk of water entering during heavy rain. Also, ensure that the doors and windows open and close smoothly, with no gaps or weak points around the frames. Pvc Self-adhesive Floor Stickers pvc self adhesive flooring,peel and stick vinyl floor stickers,removable vinyl floor stickers,PVC floor glue floor sticker,pvc adhesive floor wallpaper JIANGSU ARTSTYLE DECORATION MATERIALS CO..LTD , https://www.artstyledecor.com